What i do while bleeding the clutch hydraulics is as follows:
1. Attach a pipe to the nipple on the slave cylinder (attached to the front of the gearbox)
2. Take clutch fluid in a cup and dip the pipe in the cup
3. Open the cap of the CLutch fluid reservoir on the clutch master cylinder...make someone stand over there with a can of clutch fluid in his hand so that he can pour fluid when the level comes down.
4. Loosen the nipple on the slave cylinder and then Make someone pump the clutch so that the clutch fluid comes out into the cup containing some more clutch fluid every time the clutch is pumped.
5. Continue to do this until u notice that no more air bubbles come out of the nipple into the cup of clutch fluid. When done, tighten the nipple while having the clutch pedal in full pressed position.
That shud do it.