tdo4 turbo

[garry goodall]

iam looking to get a tdo4 setup soon, will any tdo4 turbo fit the manifolds and decats found in the traders on this site, i found one for £70 of a wrx import.
thanks in advance.

 

[Matchew]

That'll be fine fella just getta td04L all will be grand

 

[somal]

lots of info here for u dude

 

[garry goodall]

what the l stand for?
does it have to be tdo4l or will a tdo4 do, whats the difference?

 

[ginor]

Don't think it stands for anything in particular mate tbh, not 100% tho.

 

[starbogt]

lot more too it than just the L the one from the wrx etc is fine for the normal application. the flanges as long as you know which route you're going down !!! ie 3 bolt subaru fitment or the 4 stud mitsubishi!!! Do you know what mani from the traders etc you're using as there are different ones.

 

[garry goodall]

just got a dp and cat off ebay after reading a good review on them...

http://cgi.ebay.co.uk/Toyota-Starle...arts_Vehicles_CarParts_SM&hash=item519308bc7a

are you refering to the manifold side with respect to the studs??

 

[starbogt]

that kits for the subaru 3 stud td04L etc, yes mani side for turbo.

good find btw might replace mine mmmm

 

[garry goodall]

ok now i am tryin to decide what route am going down with regard to fueling, i am going to start with 0.8bar boost with just a fuel pressure regulator set up with a rolling road, then in the near future i am gunna get some management, will i still see gains at 0.8 bar over the ct9 or should i get a fcd and set at a bar with my ebc?

 

[jjayokocha]

yes with the proper mods and fcd with ebc, td04 @ .9bar shud see just over the 200hp mark