timing marks on bottem end 10 - 0??

[Dean-JDM-ep*1]

ok basically i need to know where the bottom pully markings should be set on?
when my cams and distributer are all lined up? the 2 markings are (10 and 0)on the bottom pully. im sure its 0 but not 100% could someone please confirm. i really dont want piston clash!

someone lent on the car when it was in gear, and moved to bottom end timing markings when my head was off been pressure tested lol

thanks again Dean

 

[pkn]

it should be set to 0

 

[billybob]

if you have the crank pulley off lad you will see a mark on the oil pump just set the crank gear nocth to that mark on the oil pump you should be good ,,its should be set to 0 then

 

[damussi]

it should be set to 0 . you would use the 10 mark when setting ur timing via a timing light

 

[Dean-JDM-ep*1]

i still have the crank pully attached so just using the timing notch on the crank pully so its definatly 0?

thanks Dean

 

[billybob]

yes lad but theres a bit to do when setting up your timing belt right.