carrington865
Member +
hi guys. im a noob to this site. i have a 96 glanza
i have a induction kit, TRD system aleady fitted.
i have a HkS FCD, walbro fuel pump, HKS actuator, greddy boost controller at home waiting to go on. i have a new SPS manifold coming through in post. will be ordering a HDI FMIC next month most probs through SPS dane
i am planning to run the car at .9 to 1.0 bar. what do you recon i should expect from the car BHP and torque figures?? still using standard ct9
i am gna put the motor on rollers to get figure but i clueless as to what should roughly make
i have a induction kit, TRD system aleady fitted.
i have a HkS FCD, walbro fuel pump, HKS actuator, greddy boost controller at home waiting to go on. i have a new SPS manifold coming through in post. will be ordering a HDI FMIC next month most probs through SPS dane
i am planning to run the car at .9 to 1.0 bar. what do you recon i should expect from the car BHP and torque figures?? still using standard ct9
i am gna put the motor on rollers to get figure but i clueless as to what should roughly make