Will fitting my fmic and getting a manifold and fitting that cause boost creep?

[danwheeler2k11]

Hi ive had my afrs setup on the dyno im running .9 bar and had the fueling setup on the dyno and i just need to fit my front mount intercooler and get a tubular aftermarket manifold and fit that, its the last things to get engine wise.
But will fitting either of these cause boost creep? as i will be fucked of if they will because ive had it all setup now and dont want to it to mess up.

 

[AdamB]

Why didn't you wait till you had all the bits on together then?

 

[duratec7s]

not just boost creep dude, intake temps will be lower amoungst many things. will need to be mapped again to get best from it.

 

[danwheeler2k11]

because i put my fpr on so i needed to have it checked/setup on the rollers, didnt want to be driving around super rich, lean etc.
it ent been mapped pal just adjusted on the fpr.
should be alright aslong as it dont get boost creep, mind you, could always just knock it back down to .9 bar on the actuator if it did