Any reviews on these Bob?
What size would you recommend for my forged td04 build?? 1.2mm?
Thanks,
John
what pistons u using ? ive built engines with .6 mm trd gaskets that have been making big power no probs one is 312hp its not all about the gasket u gota see what dish is in the pistons then work out what cr u wantprobably 1.4 bar max
will be daily driven so i want around 250+bhp, what boost would you recommend for driving it daily?
thanks
what pistons u using ? ive built engines with .6 mm trd gaskets that have been making big power no probs one is 312hp its not all about the gasket u gota see what dish is in the pistons then work out what cr u want
Hmm, thats why i need all help i can get... still learning!
i havent a clue on cr to be honest with you dude, i was just told to use 74.5mm 10cc low comp wiseco pistons and a 1.2mm head gasket.
John
you be looking at a compression of around (roughly) 7.5:1
i'm using wossner pistons, and there 6cc dish and my cr is 7.84:1
this is with a 1.2mm gasket
ok and how do i calculate my compression ratio?
first engine build so not too sure on some things, why is it important to take compression into consideration?
John
Ohh right, now I know!
So I'm safe to use 1.4 Bar max of boost with my setup?
you could run 1.6 bar or even 2bar boost with the wiseco pistons and the 1.2mm gasket.
but yeah 1.4 bar boost will be more than fine.
sorry to hijack ur thread bob
would be fine if the head and block are skimmed Lew
would be fine if the head and block are skimmed Lew