Hi Guys,
Ive just fitted a SBC ID and have roadtested it and it doesnt seem to be holding the boost or controlling it.
The unit was second hand and i reset the controller before setting it up. Ive got CH1 set at 0.65 but on road test it boosted way over this and hit fuel cut at one point. I expected it to be similar to the low boost setting on the original solenoid. The speed map setting is turned off as I havnt setup the power meter yet.
(Speed calibration hasnt been setup on the Power Meter hence the peak reading is over the legal speed limit)
I bypassed the stock Hi/Lo solenoid when I 1st got the car and ive installed the solenoid on top the ABS unit with all new pipes and clips:
Ive taken the boost reading from below which reads fine:
Can anyone see anything wrong with how I have fitted it or is there anything im missing with regards to setting it up, or do you think the unit may be faulty?
Anyone know how to test the solenoid?
Any help appreciated,
Adam
Ive just fitted a SBC ID and have roadtested it and it doesnt seem to be holding the boost or controlling it.
The unit was second hand and i reset the controller before setting it up. Ive got CH1 set at 0.65 but on road test it boosted way over this and hit fuel cut at one point. I expected it to be similar to the low boost setting on the original solenoid. The speed map setting is turned off as I havnt setup the power meter yet.
(Speed calibration hasnt been setup on the Power Meter hence the peak reading is over the legal speed limit)
I bypassed the stock Hi/Lo solenoid when I 1st got the car and ive installed the solenoid on top the ABS unit with all new pipes and clips:
Ive taken the boost reading from below which reads fine:
Can anyone see anything wrong with how I have fitted it or is there anything im missing with regards to setting it up, or do you think the unit may be faulty?
Anyone know how to test the solenoid?
Any help appreciated,
Adam