Recent content by leigh571

hi, i have the blitz exhaust on my glanza i had problems with it hanging too low but only after i had it lowered, i had to get it modified at my local powerflow dealer. It was the front part from the cat down because it didn't fit in where the exhaust should sit which put the rest of it out of...

what about TRD lowered springs? approx -25mm anyone got them on there glanza?

my glanza is lowered about 40mm on springs and wondered if there are any other springs out there that only lower the car about 20-25mm as its a bit too low for me as it is thanks

hi the clutch on my glanza as started to slip so will be looking to replace it only running standard set up what are everyones recommendations for a replacement, how long does it take to replace it and roughly how much am i looking at paying thanks

the whole exhaust seems to sit about an inch from the underside of the car and the bits (flanges i think they are called) where they are bolted together are a little lower

i have a blitz nur spec r exhaust on my glanza and i have just had it lowered 40mm (which from what i gather is fairly average on the glanza) but i seem to have a problem now with the exhaust. It seems to hang quite low under the car which is causing me problems with speed humps and the ramp at...

i am having my tracking on my glanza done tomorrow and just wondered if anyone can tell me the toe in/out settings i only have it lowered 40mm on springs thanks

hi could some one tell me the part number for the rear exhaust mount on the glanza (the one for the back box part of the exhaust) thanks:)

i had a blitz nur spec r cat back system on my car about 4/5 months ago and have found that it never stays in the centre of the exhaust cut out in the bumper, it is nearly always sitting too the right quite close to the actual bumper is this a common thing with this exhaust :confused:

Does anyone know the part number for the glanza sticker on the grille on the 98 spec front bumper (96 spec is a badge)

hi i am having my glanza lowered next week on blitz springs (standard shockers) the drop is going to be 35-40mm, i have got 15'' alloys and wondered if i am gonna have trouble going over speed humps thanks

hi guys i know the usual things to look out for relating to turbo wear/failure, but are there any garages/companies that will actually physically check the turbo for me. thanks

hey might see u around i'm in stafford nice lookin car by the way

part numbers i used from another post on here actually Foglights 81210-13040 Right hand 81220-13040 Left hand. 81481-10030 Clips (need four of them) 52119-10907 Bumper 531111 0460 grill

i paid £235 for it all