Recent content by PPH

Ok, it is most likely pump. It started to work without doing anything. Probably there was some shake while driving. My car was rejected from MOT because washer did not work, one month time to re-check. Probably it is better to change pump before going to re-check. With my luck it will fail just...

Not yet. Because I think I have to remove tire and fender liner for checking motor, I wanted to check easier things first that I can check outside. For liner removal I have to drive to garage which is about 1.5 hours drive. So cold here (Finland) already that I do not want to do bigger things...

My 1998 Glanza V windshield washer stopped working. Motor is not running. Did not find fuse for it, is there separate fuse for washer and if so, where it is located? Or is there relay for washer? Just wanted to check easy things first, motor seems to be little bit harder to reach because need to...

Did check hoses and reset ecu, don't know what it was, but did not lit check light anymore. Still it did run quite badly. Now I bought cheap timing lamp and ignition was about 2 degrees , set it to 10 and now it seems to run Ok. Somehow I thought that it won't affect on ignition timing if I...

I changed clutch, timing belt and lot of smaller parts for my Glanza. After repair it started to performing bad on high load. It works quite good on small load on low rpm, but on highway speed it does not accelerate as good as earlier and it also having kind of disorder in running, although it...

Old post, but I end up with this image with google image search. That is my Glanza and headlight conversion done by me. It is basically Hella Bi-halogens fitted into factory headlights which does not have front glass at all. Kind of quick and dirty way to get legal LHD lights to glanza and my...

Anwering to myself. Find out russian page with diagrams. There seems to be 6 different kinds of bulbs, not sure about socket types yet. http://toyotamarket.ru/jp/121150/006/4/8301/2/83100B/

Hi Sorry if this issue is covered somewhere, did not find clear answer with search. I have some bulbs broken in Glanza dash, and I'm thinking to change all of those at same time to LEDs. However, I like to order those before hand and I do not know how many bulbs there are and which types? Is...

Decided to go with new BC Racing set. I got answer from TEIN that S-tech springs fit to these dampers, if somebody else is facing same problems with these:

Thanks for the tip. But those inspectors are so strict here in Finland that if they notice that there is new coil setup they will be asking some papers or certificates if those are intended to specific vehicle :)

Most likely it is DIY with some original type spring. Damper is however adjustable, there is some adjust knob in top. Wondering if I could install non-turbo spring to it, is there much difference in non-turbo and Glanza V springs? I could get non turbo springs as spare parts, but haven't found...

I have problem with my -98 Glanza V, other front spring is broken. However, the coilover that is installed in Japan seems to be little bit strange. Spring diameter is much wider than usually seen in coils. It is about 16cm in lower end and about 13cm in upper end. Wonder if this is actually...

I wonder why there is limitations for words for search? I cannot search words with just three letters. But in car terminology and trademarks there are many short words and abbreviations, like ECU, EMU, FCD, HKS, TRD etc. For example in classified forums it would be great to search what kind of...

I changed connections like in picture. I used those unused relay coils as load resistance. I think it works now ok.

Where is Starlets own driving light relay located? I think I try to get high signal directly before car own relay to High beam reflectors. I think car own relay is somehow working incorrectly, because loads are different than usual, so I think it is better to use signal direcly from high/low...