Search results

There was a major missing in car today, checked it that was a faulty spark plug wire, now i can't find stock plug wires here, even im planning to get a td04 with all supporting mods so want to know what type of ignition leads i need ? 8mm ? which spark plugs will fit in 4efte ?

I have 2 4efte engines. 1st 4efte compression results: Cylinder no.1 = 150 Cylinder no. 2 = 150 Cylinder no. 3 = 145 Cylinder no. 4 = 150 2nd 4efte compression results: Cylinder no.1 = 138 Cylinder no.2 = 140 Cylinder no. 3 = 140 Cylinder no. 4 = 160 are these results satisfactory ?

What is the standard ignition timing ? after rebuild mechanic set it to 0, but now i have retarded the distributor a bit to set it at 10 with the timing gun. now its at 10 degree. it doesn't felt any noticeable difference in drive, want to raise boost to 0.8 bar is it okay with this setting of...

want to know pros and cons of sprung & unsprung 6 puck copper ceramic clutches.

I have a Tomei Fuel pressure regulator, on cold start gauge shows 2.5 bar when the car gets warmer it drops to around 2.0 bar, im planning to raise boost to 0.8 bar, so today i tried to raise the fuel pressure but its not rising its sticking to 2.5 bar, it is able to decrease pressure to 2.0 bar...

i've found a walbro fuel pump that's GRJ285, can't find any info about this fuel pump, it would be helpful if i could know how much LPH is this. walbro gss340,341 & 342 are 255lph but this GRJ285 is unknown pump!

I have a blown piston, piston no.1 but here oem pistons for 4efte are not available there are only 5efe pistons, i found a set of 5efe pistons which haave no dome and no dish, would these pistons be able to handle 1.2 bar boost as same as the oem 4efte pistons does? anyone here running 5efe...

Want to upgrade turbo from ct9 to any other, aiming for 1.2 bar boost on stock internals ,need suggestions on turbo for running this amount of boost, TD04/TD05 are very common, looking for some garrett turbocharger, lag isn't a issue for me although looking for a turbo with a bit of lag :haha:

white smoke is coming out of rocker cover breather, there is some oil residue on intake side of the turbo, what could be the possible cause of white smoke coming out of breather? bad pistons ?