Search results

maybe they already have too much MENERGY! lol or because youve put NSFW are waiting to finish work and have a look at home...

As said yday 280 is not to be sniffed at, just be prepared for the tyre bills lol I still think theres more in her but its the matter of putting it all down! kudos to you mate for sticking with it, time to enjoy it!!

Only thing I can advise is make sure the HKS actuator gets installed correctly, the golden nipple that fits inside the vac tube plays an important part in stabilising the pressure. Apart from a split hose my actuator has been holding boost very well.

No worries Sacha pm sent :rockon:

Sorry for the delay guys, been waiting on some money to clear but all is well now. Sacha payment sent :)

just a thought here but.... what if you raised just the back of tmic along with raising bonnet at back, both equal and by a fair bit then gettin a sheet of metal flat on tmic bracket to direct air and shield heat soak. to be honest though seems a lot of effort when you consider how cheap...

1. affy 2. gryzor 3. andrewvturbo 4. Blak_Mamber 5. Sound Per4mance VI 6. TO82 7. ninja1270 8. Glanza_K31 9. 10. 11. 12. 13. 14. 15.

Might be worth checking where your mani and downpipe meet up... i.e. head to mani, mani to turbo, turbo to downpipe could just be something as simple as a gaskets gone

Spark Plug Chart: Link

Couple of simple ways but obviously getting a wideband air/fuel meter would be best: After a some heavy driving you can either check the fumes of the exhaust stinks of petrol = overfueling, stinks of a rather bitter stench that stings your eyes = lean lol OR you can check your plugs again...

lol! out numbered indeed, you might as well sleep till birth as you wont be experiencing it in a long time :haha: im lucky i get to enjoy the company of a lil one (sister 2months with) without the hassle, can simply pass the baby back to sister :cool: the joys of unclehood

Congrats Kelly & Ben!! Would i be right in saying things will be a lil easier as this is your second? i.e. will be a lil more prepared and know what to expect.

Not actually sure how many people on here are chinese but: HAPPY CHINESE NEW YEAR people! GONG HEI FAT CHOI! Lets all hope this years better than the last in regards to both health and wealth :rockon:

Step 1) disconnect battery for a good while Step 2) remove screws either side of wheel iirc some dont come out completely they hold the airbag section in Step 3) remove airbag revealing inside where the big mother of a bolt that holds wheel on, undo bolt Step 4) While wiggling up down...

Cmon people, someone must know what these three fuses are for?

Congrats in getting the job mate, all the best

Ok will do, thanks.

bump?

May those involved R.I.P, must be so difficult for their families

Happy Birthday Kon!