Search results

For sale: JL Audio 12w3v2-d4 (DVC 4ohm per coil) Item Condition: Used for 6 months in my sisters car, new before that. She is not keen on shaking loud bass so never ran over 80rms although will handle 300rms if you have a decent amp. It has never been sent a clipped signal and was bought...

1992 ep82/ BREAKING/ lots of mods BREAKING IN 2 WEEKS For sale: EP82 1992 with little engine issue. Item Condition: Mettallic Clanging noise from engine on acceleration up to about 3k revs. few mechanics said Big end shells/bearings. I have lost my job and cannot afford to fix the...

as title in good condition, cash waiting. please pm

as title guys :)

woke up this morning to find that about 7 random new cars from new zetecs to new minis, mercs etc had been covered with paint stripper last night on my road! police have been rung by all of them and did not even turn up. the cars are half polished steel now where the stripper fluid had gone...

road runner clutch recieved today fella. item as described. good price and packaged well thanks:)

taken me ages to get the engine how i want it. thought id post up the before and after photos as i have done all the work i wanted to do to give me max on a ct9 and i actually dont feel the need to do anymore now unless i get a bigger turbo!

as title says. i need one for the gt but the guy has a glanza one, is it the same?? rep for help :)

please does anyone know the size of the banjo fitment on the oil return/feed so i can get a custom oil feed made up. im stuck without this size. rep will be given :)

Recently put on an sps mani and with the turbo being slightly off place, the feed is under a little strain and is leaking (the odd bit of oil on the pipe) from the gasket due to the extra pressure of having to be stretched out of place slightly. it is not leaking from anywhere else apart grom...

i have slackened off the bolt under the power steering pulley but the pulley wont drop down or slacken the belt. the belt doesnt seem to slacken. any ideas, am i doin anything wrong? the tentioner bolt is undone alot and not in contact with the pump housing anymore so it should drop but it...

As title. Anyone in NW that will do this at a competative price and a decent job?? Manchester, lancashire, yorkshire etc.. thanks

most people set the fuel pressure to 3 bar for a bar of boost. is this with or without the vacuum line attached? thanks:)

I need to order an FPR today and haver looked at the sard and FSE competition. I didnt look at the normal FSE rising rate until now and wanted opinions on who uses what and why. If the differences are cosmetic, i will get the cheaper one. I do not intend to run over 220 BHP so am curious as to...

For sale:Boost T MBC Item Condition: Used for a Month then bought an EVC 4 so not needed anymore, mint condition Price and price conditions: £40 delivered (recorded next day) to UK or pick up for £35, must pay via paypal. you dont need to add 4% :) No offers as a mate will take...

Click here to see Video

Bought a Jam FCC and asked for next day recorded. delivered on time and packaged well. not tested yet but looks fine good seller and promp postage.:)

anyone know if there are any disadvantages apart from the oil light not coming on?? i ordered a tpiece to fit a sender but the sender arrived and is massive (wide), and wont fit in the space so wondering if i can just screw it in place of the original sender without ruining summin? thanks

just curious if it is possible to do without removing anything else?? ie:turbo thanks guys

i have ordered an oil press gauge and was wondering if anyont knew the sizes of the t piece i require for screwing into the block then having the original pressure switch screw into the other side?? i know the side hole for the gauge will be 1/8npt but not sure of the bit that screws into...