Search results

So u guyz means I am already utilising all right now..

Have reduced the timing to match on the high boost..

Anyone??

Hi Team, am using a GT28R on my 4efte. have installed all supporting mods. a few main listed below. oil cooler Walbro 255Lph DMC 450 (Black) VAFC 2 RRFPR exedy stage 2 clutch and pressure plate HKS BOV FMIC Engine internals are all stock. Currently m running 1bar of boost with...

some mates are saying that no need of injectors.. the stocks will support till 1 bar with an FPR... ?? not sure what to do...

m not sure mate.. i m planing to run 1.2bar.. plz advice :confused:

At least 1 bar :) .. to get some advantage out of it.. As already mensioned by my mate gorganl2000 .. its not usefull torun it at 0.5 bar..

Hi Mates.. after all.. GT28r inside.. running 0.5bar to b at safe side.. was wondering what injectors to put in ... as i read a lot of Mates using 330ccz .. is it ok , i mean 330 seams a small figure . was planing for some 450cc .. but again this forum has helped he a lot so again as usuall i m...

or the ones which came in EVOs ??

550 :eek: ..ok..but which ones? the supra ones?

i have FPR and will be going for some fuel management.. but i m confused for the right injectors... A frnd of mine here is using DSM 450cc ones with his TD04....

m wondering what will be the best upgrade for my 4E injectors .. as my car is at the fabricator for the new turbo setup.. a GT28R is coming in.. Tomorrow, it will be with me for a tune.. So guyz kindly advice what injectors to use with GT28r..??

ok. so its repairable... mate right now i have rrfpr.. but stock injectors, ECU will be unaffordable right now.. m planing to run it low for some time and will go for injectors and some SAFC.. but r u sure 315 will be the right ones??

will 5efhe head fits 4efte.. and if yes.. so what will be the advantage to 5efhe head over 4efte head??

ok guyz.. its getting on ... so what other mods will be required .. Like injectors,etc..?

had this same issue... you will need to take out the head and take it to some welder .. this will do the .. i got mine welded and no prob after that...

i used it for my 4EFTE

Yup.. the clutch will fit.. its 212mm and 21 spine counts.. i ordered this from ebay.. though it was not good but it fitted... F1 Racing 6-puck sprung copper ceramic disc (215mm x 21 spline) for my 90-92 COROLLA GTS 4AGE.. i would advice that use the non spring one..

the guys selling this said its a GT28R...

yup its me... its a ball bearing one.. non repairable... so no rebuild...