Search results

  1. P

    Is Glanza windshield washer behind same fuse as windshield wiper?

    My 1998 Glanza V windshield washer stopped working. Motor is not running. Did not find fuse for it, is there separate fuse for washer and if so, where it is located? Or is there relay for washer? Just wanted to check easy things first, motor seems to be little bit harder to reach because need to...
  2. P

    Fuel cut after repair

    I changed clutch, timing belt and lot of smaller parts for my Glanza. After repair it started to performing bad on high load. It works quite good on small load on low rpm, but on highway speed it does not accelerate as good as earlier and it also having kind of disorder in running, although it...
  3. P

    Glanza dash bulb type

    Hi Sorry if this issue is covered somewhere, did not find clear answer with search. I have some bulbs broken in Glanza dash, and I'm thinking to change all of those at same time to LEDs. However, I like to order those before hand and I do not know how many bulbs there are and which types? Is...
  4. P

    Strange coilover setup in front

    I have problem with my -98 Glanza V, other front spring is broken. However, the coilover that is installed in Japan seems to be little bit strange. Spring diameter is much wider than usually seen in coils. It is about 16cm in lower end and about 13cm in upper end. Wonder if this is actually...
  5. P

    Shearch, too short word

    I wonder why there is limitations for words for search? I cannot search words with just three letters. But in car terminology and trademarks there are many short words and abbreviations, like ECU, EMU, FCD, HKS, TRD etc. For example in classified forums it would be great to search what kind of...
  6. P

    Driving light connectors

    I have installed Hella Bi-halogen projector driving lights to my Glanza (needed to have some solution for getting LHD lights). Those Bi-halogen lights have only one H7 bulb and reflector which is used to applying high beam. I used one relay to switch between high and low beam. Now I have such...
Top