4EFTE Wiseco Pistons and Pauter Rods

Status
Not open for further replies.
J

Jeffers_21

Member +
Yeh i think most ppl go for the 74.5mm ones. When i did it the bore out and that was to much work that i didnt really need to do, and at the time i didnt see there was much in the way of gain from it. i still made 272bhp on my k26
 
whiteglanzav

whiteglanzav

Member +
these are a bargain at that price !! especially as they include delivery, and being 74mm- if ur engine runs fine u can just swap these in, but bear in mind the block will probli have to be notched
 
J

Jeffers_21

Member +
didnt notice the notched comment. yeh you dont need notching with the pauters they just drop straight in, you do have to give the bores a good hone tho.
 
J

Jeffers_21

Member +
Sorry forgot to say im looking for

£360 for the rods
£225 for the pistons

offer's around these price's will be considered but not silly low offers
 
stew

stew

Member +
brace for noob question: do i need anything other than these rods/pistons to make my engine fully forged?
 
J

Jeffers_21

Member +
cheers for replying whiteglanza. yeh i would recomend a new set of bearings and it really depends on what your crank is like but the pistons and rods are all that really makes an engine fordged
 
J

Jeffers_21

Member +
thats the problem at the moment, most ppl are being a lil tight with money so you never know they will most prob still be around lol.
 
J

Jeffers_21

Member +
Ok im loweing the price of the rods to £345 someone grab a bargin for the best rods you can get.
 
Last edited:
Status
Not open for further replies.
Top