Hello,
I have just installed my FPR because on my AEM Wideband it was saying that it was running 10,5..
So i was testing it on full thottle with the FPR..
But after some time 4 or 5 times running around..
The Engine Light comes on.. so i did a diagnost.. and it was code 52..
That says Knock sensor..
But what can i do now? If i turn the car on now the engine light wil go on after some time..
My Specs :
Aftermarkted Manifold
Jperformance Decat
Tanabe 2,25inch Cat-back
GB FCD
FMIC
Filter relocator
And it runs without silincer 0,9 a 1bar
And with silincer 0,7 a 0,8bar
Hope some one can tell me what's wrong..
Greetings,
Jeroen
I have just installed my FPR because on my AEM Wideband it was saying that it was running 10,5..
So i was testing it on full thottle with the FPR..
But after some time 4 or 5 times running around..
The Engine Light comes on.. so i did a diagnost.. and it was code 52..
That says Knock sensor..
But what can i do now? If i turn the car on now the engine light wil go on after some time..
My Specs :
Aftermarkted Manifold
Jperformance Decat
Tanabe 2,25inch Cat-back
GB FCD
FMIC
Filter relocator
And it runs without silincer 0,9 a 1bar
And with silincer 0,7 a 0,8bar
Hope some one can tell me what's wrong..
Greetings,
Jeroen