Engine mount loose?

addz

Member +
I will be replacing bushes soon, got a few quick questions.

I know i'll have to jack up engine from sump to hold weight for driver side engine mount, where do i jack for the other two engine mounts when replacing?

Thanks:)
 

weeJohn

Lifer
I undertook an oil change, started the car up to check the oil level as you do..

Dont want to make an issue out of this but starting the engine is not the best thing to do.

Best to remove the king lead from the distributor, remove the injector plugs, then turn the car over using the ignition until the oil pressure light goes out.

This insures the new filter is loaded with oil as well as all the oil galleries and removing the injector plugs means the barrell is not washed of oil either.

By the time it takes to put the leads back on the oil will have nearly settled back into the sump to check the levels.
 

addz

Member +
Dont want to make an issue out of this but starting the engine is not the best thing to do.

Best to remove the king lead from the distributor, remove the injector plugs, then turn the car over using the ignition until the oil pressure light goes out.

This insures the new filter is loaded with oil as well as all the oil galleries and removing the injector plugs means the barrell is not washed of oil either.

By the time it takes to put the leads back on the oil will have nearly settled back into the sump to check the levels.

This was done after getting a possitive reading on the dipstick, start up to make sure levels havent dropped by much, if so put a tad more in.

I wasnt doing this bone dry, there was sufficient amount of oil in engine.

Thanks
 

addz

Member +
do one at a time mate. then you can move jack about.

i'll give you a hand if you want?


Ite fella. I should be cool with it as Zippo might be there to give a helping hand.

I got powerflex bushes, you comming out tonight?
 
Top