Ep82 e manage unlimited

[Brian Farrell]

Hi all I just bought e manage ultimate have main harness installed .what position should dip switch be in?also do I need to set up jumpers ?? Do you leave old map sensor pluged in?
Not sure what to do any help greatly appreciated.

 

[Jay]

Hi Brian,

I've not wired one of these in or set one up but here's a link to the Greddy installation guides that might help:

http://www.greddy.com/tech-support/e-manage

If you are planning to run over a bar of boost (1.5 for example) the stock MAP sensor will not give an accurate reading as that's outside it's range. A 3-bar sensor would give the ECU a real reading of what's going on and that'll allow a finer tune instead of any guesswork.

Hope that helps,

Jay