No mate,..your loom will not bolt in without some wiring.
so even if i take my whole loom from my gt and put it into the ep85,i still have some wiring to do?
No mate,..your loom will not bolt in without some wiring.
so even if i take my whole loom from my gt and put it into the ep85,i still have some wiring to do?
With that path you won't even need a soldering iron mate..
thanks lads,thats another question answered!lol
id give u a hand if u ever went down that route.so even if i take my whole loom from my gt and put it into the ep85,i still have some wiring to do?
id give u a hand if u ever went down that route.
Loom in a EP91-95 swap is not a direct change over, small amount of soldering is required. other differences are manual air bag to electronic, heater controls, abs, fuel gauge and pump differences in all these. You must be careful what ep91 you use the loom from.
will you bring me for a spin sometime john!?
so even if i take my whole loom from my gt and put it into the ep85,i still have some wiring to do?
You guys are going about this all wrong.
If your going to do this, do it right.
Use the full drivetrain (incl engine) from a ST165/ST185/ST205 (Celica GT4).
That's everybody's dream mate,...but we have to keep it realistic . Time and money and resources will be the challenge to have the 3sgte setup in there.
just sent enquiery for a ep95 :rockon:
lets get the project rolling . . . :drive:
Brown FTMFW :haha: