Flywheel torque setting

[aar-on06]

Does the flywheel have to be done up to a specific torque setting. or can i just do it up as tight as i can and leave it at that.

If it does need to be done up to specific torque settings, what are they ? thanks

 

[Texx]

The flywheel bolts need some thread sealant on them before you tighten them to 90Nm.

 

[Jay]

88nm and remember to use thread lock.

Jay

 

[Texx]

Whatever you use on the bolt threads, make sure it's suitable to seal and prevent oil leakage. A typical thread lock will leave the possibility of an oil leak at the back of the engine. This stuff is the nuts:

http://uk.farnell.com/permatex/56750/thread-sealant-high-perf-temp-50ml/dp/1862896