Forged Glanza +290bhp Massive Spec

garioch

Member +
Forged Glanza +290bhp Massive Spec Gauging Interest For Breaking It Now

For sale: Glanza

Item Condition: Used

Price and price conditions: £7000

Extra Info:
I am regrettably selling my glanza which I have owned for two years because I am looking to put a deposit down on a flat. In the time I have owned it there has been no expense spared when it came to modifying and maintaining it. I have thoroughly enjoyed this car but the time has come for me to sell it.
It has only done 6k miles since being fully rebuilt last summer and was kept off the road and garaged all winter. The clocks read 93000 which is a mixture of mostly km’s and some miles, although most major parts were replaced during the rebuild.

Here’s a brief spec:

MOT – Oct 10 (can put new MOT on it for new buyer if needed)
Tax – May 11

Engine
Wiesco Low Compression Pistons 74.5mm
Scat H-Beam Forged Conrods
ACL Bottom End Race Bearing Kit
Block Professionally Rebored and Honed
ZEP 1.2mm Head Gasket
Ported and Polished Head
Heavy Duty Valve Springs
265deg Billet Cams with 8mm Lift
New Toyota Cambelt Kit
New Toyota Water Pump
New Toyota Oil Pump
New Toyota Engine Gasket Set
Mocal Thermostatic Sandwich Plate
Mocal 19 Row Oil Cooler
Magnacore HT Leads
Garrett GT2871r
Tial 38mm Ext. Wastegate with Screamer Pipe
Equal Length Ceramic Coated Manifold
3” Custom Side Exit Exhaust
Apexi Power FC Engine Management
Apexi Power FC Hand Controller
AEM Wideband Sensor
GReddy Electronic Boost Controller
Walbro 255lph Fuel Pump
RC 660cc Injectors
Sard Fuel Pressure Regulator
2.5” Custom Intercooler Piping
Evo Intercooler
JC Project Lightened Flywheel
OEM Toyota LSD
ACT Paddle Clutch

Handling
BC Racing Coilovers
Whiteline Front ARB
Whiteline Rear ARB
Powerflex Engine Mounts
Poly Bushed Bottom Arms
Toyo r888’s
Front Strut Brace
Wilwood 4pot 3G Big Brake Kit
Braided Front Brake Pipes

Exterior
Laguna Front Splitter
15” Rota Slipstreams
Rear Windows Tinted

Interior
Double Piller Pod
AEM Wideband Gauge
Boost Gauge
Sparc o Racing Steering Wheel
GReddy Boost Controller
TOAD Alarm and Immobilizer

The car made 290bhp@1.2bar(244bhpATW) mapped by AVA

It has always been run on silkolene pro 5w40 oil, changed every 2k

I also have an AP racing clutch here which I had custom made costing over £1k to cope with the extra power, this will allow for an increase in boost pressure.

I’m looking for around £7000. I have loads of receipts here to verify all the work which has been done. No Dreamers or Tyre Kickers please, this is a serious car and I’d appreciate serious inquires only.

Viewing Welcome.

If you have any other questions or would like specific photos please just ask.

Pictures:
DSCN1942.jpg

DSCN1962.jpg

DSCN1929.jpg


Contact Details: 07521234358 or Pm me

Location: Falkirk, Central Scotland

Delivery & Conditions of Delivery: Pick Up
 
Last edited:

Dane_Bristol

Member +
My starlet is in the same sort of price range mate. If you are anything like me then i wouldnt accept anything less than my asking price.

Well then again i am not bothered if it sells or not, all i know is i wont be letting it go without someone paying a decent price otherwise my opinion is that i keep it.

Good luck with the sale.
 

AdDaMan

Member +
lovely car mate but as said you need to break it. youll get MUCH more that way.
Also i thought youd be well over 320bhp on a 2871r with cams at 1.2bar?!
 

richglanzav

Member +
sure i seen one make 320 at 1.5bar on same turbo? seems bout right to me. lovely car either way tho. good luck i hope some1 buys her whole. shame to break cars of this kind of spec
 

After-Glanza

Member +
dantheman's old gt made 320 at 1.5bar and 347 at 1.8bar so the figures seem to be spot on. Lovely car and a very nice spec on it. Nice to see a less common turbo choice. Good luck with the sale.
 

gv1.3

Admin
Off topic posts removed - if you have nothing to add to this thread except commenting on the asking price please do this member the courtesy of not posting in his for sale thread.
 

garioch

Member +
Just putting the feelers out to see how much interest i would get if i decided to split.

Depending on how much interest would depend if i break or not. If i get enough interest for the majority of the "big bits" then i would like to take a deposit to ensure people are genuine then i will break and post out relevent parts.

Prices do not include delivery or paypal fees.
Will accept offers.
Think everything is reasonably priced.


Engine
Wiesco Low Compression Pistons 74.5mm
Scat H-Beam Forged Conrods
ACL Bottom End Race Bearing Kit
Block Professionally Rebored and Honed
ZEP 1.2mm Head Gasket
Ported and Polished Head
Heavy Duty Valve Springs
265deg Billet Cams with 8mm Lift
New Toyota Cambelt Kit
New Toyota Water Pump
New Toyota Oil Pump
New Toyota Engine Gasket Set
£1300 - aaronw

Mocal Thermostatic Sandwich Plate
Mocal 19 Row Oil Cooler
£150 - sold


Magnacore HT Leads
£50


AMS Civic Rad
12” Slimline Fan
Blue Samco Hoses
£130 - sold

Garrett GT2871r
Tial 38mm Ext. Wastegate with Screamer Pipe
Equal Length Ceramic Coated Manifold
3” Custom Side Exit Exhaust + Bumper
£1500

Apexi Power FC Engine Management
Apexi Power FC Hand Controller
£800 - sold

AEM Wideband Sensor + Gauge
£150 - sold


GReddy Profec Spec B Electronic Boost Controller
£150

Walbro 255lph Fuel Pump
£50 - sold


RC 660cc Injectors
£200

Sard Fuel Pressure Regulator
£70 - sold



2.5” Custom Intercooler Piping
Evo Intercooler
£200 - sold

JC Project Lightened Flywheel
£70 - sold


OEM Toyota LSD Box + Shafts
£400

BC Racing Coilovers
£450 - rankin09

Whiteline Front + Rear ARB
£125 each - both sold

Whitline ALK
£50 - sold


Powerflex Engine Mounts
£50 - aaronw


Poly Bushed Bottom Arms
£80 - sold

Wilwood 4pot 3G Big Brake Kit
Braided Front Brake Pipes
£600 - sold

15” Black Rota Slipstreams + Toyo R888's
£300 - sold
 
Last edited:

turboloon

Member +
i'd deffo take the engine mounts bud is this inc gearbox..?1st dibs please.also the aem wide band...1st dibs ,also who built the engine..?give fraze dalgarno a pm ref yer power fc as he is on the lookout for management for a glanza..
 
Last edited:
dont brake it dude for somone who wants to spend money on a starlet if they add the cars goodies up thats alot more then the asking price plus it comes alredi down and ready to race lol for somone wanting a high powered import that dosent do much with engines for a car like this to me is a bargain i will me selling mine same sort of price

good luck with sale dude car its mint!!!
 

garioch

Member +
i'd deffo take the engine mounts bud is this inc gearbox..?1st dibs please.also the aem wide band...1st dibs ,also who built the engine..?give fraze dalgarno a pm ref yer power fc as he is on the lookout for management for a glanza..

front 2 are polybushed, rear is a solid alloy bush as you cant get a poly bush for the standard lsd gbox mount. already got someone for aem, will keep you in mind.
if hes interested tell him to get in touch.

Part Lists been updated.
 

aaronw

Member +
Hey mate, I 99% want your forged engine. I can tell you tomorrow at about 2pm if it'll be 100%. £1350 delivered :)
 
Top