gearbag bushes

Discussion in 'DRIVETRAIN' started by SKINY, Dec 12, 2018.

  1. SKINY

    SKINY Registered User +

    sooo this may sound random......
    came across a skateboard wheel bearing in the Sons room last night an i could swear I've seen posts about people fitting them to the cable end to replace the normally knackered rubber one. Can't find any posts now bloody typical lol
    can anybody confirm this ? Can someone measure the stud and the gearbag cable end if they have one handy cough cough Jay ;)
     
  2. TylerGlanza

    TylerGlanza Member

    Im sure i read that post recently on ukso ill see what i can find
     
    SKINY likes this.
  3. SKINY

    SKINY Registered User +

    yea I've searched here an there bud
     
  4. Jay

    Jay Admin

  5. Calum122

    Calum122 Registered User +

    ID Workz Sell thenm £20...

    Expensive, but I had to modify the cables to get them to fit.

    Tuning Developments do a replacement bush which look a million times better.
     
    Jay likes this.
  6. dac69er

    dac69er Super Moderator

    i just got a couple of bearings and washers from work for free and did mine. worked fine. a bit of an arse to install in position, but not too bad.
     
    Jay likes this.
  7. SKINY

    SKINY Registered User +

    I can confirm after today that they will fit, just need a wee tap tap tap to get it into the cable and, g-clamp would be perfect to press it in :cool:
    There is a difference in width tho compared to the factory Bush but a few large washers should sort it :D
     
    thefalls likes this.
  8. thefalls

    thefalls Registered User +

    I have done that since a while. Fit and forget.
    Bearings are 608ZZ or 608RS
     
  9. H_D

    H_D Paid Member

    anyone got any pics of them fitted?
     

Share This Page