fiddlersport
Fresh Recruit
hi
could some one please explain me where to patch in the rpm wire on the ecu for this boost controller
for glanza 4efte ecu
instruction manual states -
Notes: The RPM input wire MUST GO TO A LOW VOLTAGE SOURCE
e.g. ECU tach output, ECU to Igniter wire etc.
This wire MUST NOT go to a high voltage source e.g. coil negative
could some one please explain me where to patch in the rpm wire on the ecu for this boost controller
for glanza 4efte ecu
instruction manual states -
Notes: The RPM input wire MUST GO TO A LOW VOLTAGE SOURCE
e.g. ECU tach output, ECU to Igniter wire etc.
This wire MUST NOT go to a high voltage source e.g. coil negative
