Got block back from engineers.

[Sigma]

Just got my block back from the engineers, and they have had to take 15thou off of it to get it flat :O

Anybody ever had to take this much off? Seems like loads.

 

[Trevor]

15 thou

Thats not a lot to have taken off.Measure out 1 inch then divide it by 1000 and multiply that by 15 if you can then you'll see it's really not a lot.

Just got my block back from the engineers, and they have had to take 15thou off of it to get it flat :O

Anybody ever had to take this much off? Seems like loads.

 

[sx_turbo]

thats quite common mate,

i've known engines to need more than that off

 

[Gryzor]

0.38 mm
conversion table

 

[Sigma]

thats quite common mate,

i've known engines to need more than that off

Cheers dude

 

[Texx]

That's about the thickness of a hacksaw blade. It's nothing to be concerned about.

 

[weakboy2]

thought you had already had it skimmed??

or did you cook it again when you were running too much timing?

 

[Sigma]

Cooked it :/

I feel like such a cunt, lol.

 

[GTnomez]

I feel like such a cunt, lol.

sorry siggy but quoted for the truth :teach:

 

[350ep70gr]

Add bottom .38 mm and the result from skimming the head both to the hg thickness if you want to have the same cr as previous!

Chris

 

[riko666]

Sigma, don't worry, mine's had 30 thou removed

 

[Sigma]

Mint

The head's only had 3 thou taken off as it was pretty mint

 

[350ep70gr]

Mint

The head's only had 3 thou taken off as it was pretty mint

1,6 hg will be grand then!

Chris

 

[sam_glanz]

or go 0.6m HG and go 1.8bar sigma:haha:

 

[350ep70gr]

or go 0.6m HG and go 1.8bar sigma:haha:

I must admit you are right mate :teach:... It will make a much louder boooom...:haha:

Chris

 

[sam_glanz]

I must admit you are right mate :teach:... It will make a much louder boooom...:haha:

Chris

muchh louder:haha:

on boost http://www.youtube.com/watch?v=26imtcgjcrg

 

[danb87]

my mate, had 40thou taken off his head yesterday.