GTnomez
Member +
hi guys,
i installed my HDi ebc yesterday and i foolowed the instrcutions given. i wired up a ground, live, and ignition and connected up all plugs so there was power running through the ebc and boost gauge. i then plugged in the vaccum line and the gauge was reading the boost.
the problem is that i connected up the soleniod, i put it in between the line that goes to the actuator and to the turbo. but i am unable to adjust the boost, it still hits 1 bar. my hks actuator is set at 1 bar but when i adjust the hi lo setting, it doesnt do anything. i swapped the lines over between the actuator and turbo but still no good
any ideas??
i installed my HDi ebc yesterday and i foolowed the instrcutions given. i wired up a ground, live, and ignition and connected up all plugs so there was power running through the ebc and boost gauge. i then plugged in the vaccum line and the gauge was reading the boost.
the problem is that i connected up the soleniod, i put it in between the line that goes to the actuator and to the turbo. but i am unable to adjust the boost, it still hits 1 bar. my hks actuator is set at 1 bar but when i adjust the hi lo setting, it doesnt do anything. i swapped the lines over between the actuator and turbo but still no good
any ideas??