HKS actuator and high-lo

H

Harvey

Member +
I have heard the high-lo button still works with the hks actuator, but i have a question.

Now standard you are looking at what, 6.5psi on low boost and 9.5 on high, so a diff of 3psi.

I want to run about 10-11psi in high boost. So, does this mean i set the actuator to about 7 or 8psi, and then when i hit the high boost button i get 10-11, OR do i set the actuator to 10-11 and that gives 7-8 in low boost?

Cheers;

Harvey
 
H

hardcoreep

Member +
The ratio between HI/LO will be maintainted by retaining use of the stock solenoid. The actuator is base boost, and you can't go lower than the base boost. So if you set the actuator at 10psi then that would be LO. HI would then be +3/4psi.
 
G

GP82

Member +
How do you go 'bout the piping? I mean the stock actuator has two nipples, but HKS has only one.
 
H

hardcoreep

Member +
stockactuatorvsHKSactuator.jpg

If you bought the kit, it has a plastic T in it.
 
Last edited:
H

Harvey

Member +
Many thanks hardcoreep, thats just what i wanted to know. I will set mine to about 7psi then,

I need to find a T piece now :)
 
You must log in or register to reply here.
Top