Russel_Glanza
Member +
Hello guyz. I just got a HKS EVC 3 for my glanza.....i downloaded the installation instructions, bt couldn't figure out how to do the vacuum lines.
On the stock setup, as far as i can see, there are two nipples on the actuator: One attached to the nipple on the turbo body, and another goes to the factory boost limiter. The second nipple on the factory boost limiter goes to the intake pipe.
The instructions on the HKS EVC 3 are available at http://homepage.ntlworld.com/w.gregory2/hksevc iii.pdf (page 10).
Would greatly appreciate if anyone can see the instructions and guide me regarding the vaccum line connections. Thanks a lot.
On the stock setup, as far as i can see, there are two nipples on the actuator: One attached to the nipple on the turbo body, and another goes to the factory boost limiter. The second nipple on the factory boost limiter goes to the intake pipe.
The instructions on the HKS EVC 3 are available at http://homepage.ntlworld.com/w.gregory2/hksevc iii.pdf (page 10).
Would greatly appreciate if anyone can see the instructions and guide me regarding the vaccum line connections. Thanks a lot.