this works! i have it on my ep80.. you need (to do/buy) the following:
- reducing elbow 38mm -> 51mm (ebay: zena racing)
- elbow 51mm (have to check this one, maybe i used the stock bend from compressor outlet to tmic) (any silicone mfr)
- straight coupler 51mm (any silicone mfr)
- another straight coupler 51mm (any silicone mfr)
- straight coupler 60mm (any silicone mfr)
- some piping 51mm outer diameter (ebay)
- some piping 60mm outer diameter (ebay)
- some clamps
- cut the compressor outlet just after the 38mm -> 51mm elbow, keep the bulge to have some more grip for the 38mm -> 51mm reducing elbow!
when having all of these components lying in front of you, its pretty straightforward.. i will check if i can make some pics of my setup
having no bonnet vent, this setup almost completely removed the tmic heatsoak the engine experienced..
it does not look pretty, but it does the job
also, i don't have enough space for a decent aftermarket fmic behind my stock front bumper..