hi guys,
would like to know what is the best spec for cams to be used on a 5Efte motor,
running drag strip 350m - 400m
current setup :
fully forged internal, ( ross pistons n pauter rods )
55mm throttle body
5e high lift cams
speedvision valve springs
1.4 metal gasket
acl bearing
arp complete stud
copy of full race turbo header
garret a/r60 ballbearing turbo ( from nissan vq series - exh fin is ceramic )
e-manage ultimate - upgradin to haltech/microtech
greddy profec b spec2
2x bosch fuel pump
sard fuel regulator
custom fmic
any ideas on the spec of cams i should use to run drag strip ?
thanks a lot
would like to know what is the best spec for cams to be used on a 5Efte motor,
running drag strip 350m - 400m
current setup :
fully forged internal, ( ross pistons n pauter rods )
55mm throttle body
5e high lift cams
speedvision valve springs
1.4 metal gasket
acl bearing
arp complete stud
copy of full race turbo header
garret a/r60 ballbearing turbo ( from nissan vq series - exh fin is ceramic )
e-manage ultimate - upgradin to haltech/microtech
greddy profec b spec2
2x bosch fuel pump
sard fuel regulator
custom fmic
any ideas on the spec of cams i should use to run drag strip ?
thanks a lot