Oil Gauges

[darckskullz]

Hey i wanna put both oil pressure and temp gauges in my car.
Ive read through a good few threads but still unsure what to do i can just about join two wires but manage to wire a boost gauge, boost controller, volt meter (although i did it wrong doesn't read battery only when cars running).
Ive bought these Gauges and got this thing with them

Here's the wire's for both gauge's

Got them of a fella along time ago who had them in a evo.
Back then didn't wanna put them in until got a better turbo.

So then i found out i needed a sandwich adapter thing.
So i got this with a different sender for the gauges.

Here's the sender for it.

So this is all of what I've got.

So i basically want to know how to put these in.
Can i use the gauges on the sender of the sandwich adapter??
I think i put the sandwich thing between the oil filter and the oil filter housing. is this correct??
Then i connect a wire from from the gauges to the sender on the sandwich thing ??
Any idea which wire?? I'm guessing the green one.
Then i connect the gauges to a power and earth ya??
But see then there are two more wires??

All help greatly appreciated and will rep all who i can.
When i do get the right information to do it i will takes loads of pictures while I'm doing it and write up exactly what i did.

Didn't realize my camera was this bad sorry for poor quality.

 

[darckskullz]

Anyone?? still haven't got a chance to have a go at it with work and school

 

[hekker]

its like u said to install

the red is positive+
black is negative-
green is signal wire to sensors

 

[darckskullz]

its like u said to install

the red is positive+
black is negative-
green is signal wire to sensors

Thanks but theres two sets of black and red what do i do about them??

 

[conorIRLgt]

The extra wires are usually there if the gauge has a few colurs to choose from that's what Iv seen anyway

 

[turboloon]

you will also need to grind a piece out of the power steering bracket to get the sandwich plate to fit iirc only the greddy ones fit with out modification...why have you got those extra terminal lead connectors..?