bigdoods
Member +
I have
10cc dished wiseco pistons at 74mm standard bore
cruise 1.4mm h-g,
pauter rods,
td04l-13g turbo
He has
10cc dished wiseco pistons at 74.5mm bore,
1.2mm h-g,
pauter rods.
Td04l-13g turbo
Were both using an apexi 3bar map sensor and sard 550cc injectors
Im getting a power fc and commander off him and its mapped for 1.4 bar on the td04l turbo.this is the boost i want to run.do ye think it will be safe to plug and play?I will be plugging in a wideband also to check how shes fuelling if/when i do plug and play and will be able to stop if its not fuelling correctly.
there are the following factors im aware of
1)different fuel-hes 99 octane and im 95octane
2) the condition of the turbo could vary.
3)The compression may be slightly different?(could someone calculate this again please for the two engines as i dont know how to)
Thanks and rep for helpers
10cc dished wiseco pistons at 74mm standard bore
cruise 1.4mm h-g,
pauter rods,
td04l-13g turbo
He has
10cc dished wiseco pistons at 74.5mm bore,
1.2mm h-g,
pauter rods.
Td04l-13g turbo
Were both using an apexi 3bar map sensor and sard 550cc injectors
Im getting a power fc and commander off him and its mapped for 1.4 bar on the td04l turbo.this is the boost i want to run.do ye think it will be safe to plug and play?I will be plugging in a wideband also to check how shes fuelling if/when i do plug and play and will be able to stop if its not fuelling correctly.
there are the following factors im aware of
1)different fuel-hes 99 octane and im 95octane
2) the condition of the turbo could vary.
3)The compression may be slightly different?(could someone calculate this again please for the two engines as i dont know how to)
Thanks and rep for helpers