Removing bits around engine....Pic's inside...

Jaf_ep91

Jaf_ep91

Member +
foggy i meant the carbon cannister i need to know where to relocate the pipe as on the ep91 there isnt a small box on the inside leg?
 
Foggy

Foggy

Member +
Here is a pic. Its the yellow pipe :)

IMG_1483.jpg
 
Jaf_ep91

Jaf_ep91

Member +
can't see the video but removing the vaccums can sometimes cause a funny idle, use the idle adjusting screw on the inlet,
 
Last edited:
N

nazzurro19

Member +
i dont have a redbull can or a catch tank lol , dont worry guys i sorted the problem out , i forgot to connect the pvc back to the inlet and then i used the idle screw to adjust it to 1000rpm
 
weeJohn

weeJohn

Lifer
Removing any of that stuff should not affect the idle speed, providing you block off the spouts on the inlet mani and throttle body where they were removed from.

I removed the a/c condensor from mine the other day, its what those 2 pipes going through the bulkhead are connected to. Its behind the glove box in a black section between the fan and the heater matrix sections. 20 minute job, just undo all the plugs, the nuts top and bottom and remove the plastic section. Then take out the screws on it and remove the clips holding the 2 sections together. Then take the condensor out, fuck it in the bin, put it back together and refit it.
 
Stulet-GTT

Stulet-GTT

Member +
nazzurro19 said:
i dont have a redbull can or a catch tank lol , dont worry guys i sorted the problem out , i forgot to connect the pvc back to the inlet and then i used the idle screw to adjust it to 1000rpm
Click to expand...

Glad you got it sorted mate...

turbominicooper said:
stupid question but is that red bull can meant to be a catch tank?
Click to expand...

Yep it is, silly i know but it work's ok...

weeJohn said:
Removing any of that stuff should not affect the idle speed, providing you block off the spouts on the inlet mani and throttle body where they were removed from.

I removed the a/c condensor from mine the other day, its what those 2 pipes going through the bulkhead are connected to. Its behind the glove box in a black section between the fan and the heater matrix sections. 20 minute job, just undo all the plugs, the nuts top and bottom and remove the plastic section. Then take out the screws on it and remove the clips holding the 2 sections together. Then take the condensor out, fuck it in the bin, put it back together and refit it.
Click to expand...

Thanks for that info chap gonna give it a go soon...
 
Stulet-GTT

Stulet-GTT

Member +
Done a little more today,took weejohn's advise an ripped the a/c condensor out...

Few screew's an unplug some wires an its out...
DSCF0800.jpg


Seperate box an pull its guts out..
DSCF0801.jpg

DSCF0802.jpg


Then shove it back in...
DSCF0803.jpg


Where the pipes came out bulk head i jus taped over it for now till i get a propper bung sorted, condensor was heavyer than i thought it would be an wire loom out so lb's saved in weight...

Also can anyone tell me what this is???
DSCF0805.jpg


Just its on a big loop of pipe and an ugly braket, so i want to shorten the pipe to remove bracket...
 
You must log in or register to reply here.
Top