Boab
Member +
hey guys,
put car on rollers at East Coast Customs on tuesday. She made 163bhp and 157lb/ft @ 0.75 bar
really pleased for basically a standard setup. Here's the spec:
• CP 74.5mm Pistons (9:1 compression ratio)
• Scat Conrods
• ACL Mains Bearings
• ACL Rod Bearings
• ACL Thrust bearings
• Speedvision 1.2mm Metal Head Gasket
• Silkolene Pro S 10w50
• JAM Fuel Cut Defencer
• All new gaskets and seals all round
Turbo & Exhaust
• Bailey BOV
• HKS Adjustable Actuator
• Decat Pipe
Transmission
• CAP Uprated Paddle Clutch – Rated to 265lb/ft
next stage is a uprated pump and pressure reg so i can run more boost:rockon:
put car on rollers at East Coast Customs on tuesday. She made 163bhp and 157lb/ft @ 0.75 bar
really pleased for basically a standard setup. Here's the spec:
• CP 74.5mm Pistons (9:1 compression ratio)
• Scat Conrods
• ACL Mains Bearings
• ACL Rod Bearings
• ACL Thrust bearings
• Speedvision 1.2mm Metal Head Gasket
• Silkolene Pro S 10w50
• JAM Fuel Cut Defencer
• All new gaskets and seals all round
Turbo & Exhaust
• Bailey BOV
• HKS Adjustable Actuator
• Decat Pipe
Transmission
• CAP Uprated Paddle Clutch – Rated to 265lb/ft
next stage is a uprated pump and pressure reg so i can run more boost:rockon: