thinking about fitting coilovers myself???

[.ep82GER]

Ok lads i got my bc coilovers off bob@ecc:rockon: ....and and thinking about fitting them myself tomorrow,is it a easy or hard job to do,any tips

 

[whiteglanzav]

piece of piss mate, 4 bolts on the top, and 2 at the bottom on the front and 1 on the btm at the back !

 

[The_Notorious_C_A_T]

Really easy mate. Rears only have 3 bolts holding each one ( 2 tops of turret and 1 on axle) on and fronts are 6 bolts each (4 on turret and 2 on hubs).

 

[TURBO2010]

x2 yep as above no prob!!

 

[quadcorecraig]

easy dude ^__^ get it slammed

 

[.ep82GER]

use make it sound so easy think ill give it a go.....

 

[whiteglanzav]

use make it sound so easy think ill give it a go.....

it is easy dude !!

 

[Johnny_C]

just make sure to get your camber sorted after fitting.

 

[iamlegend]

yep iam not mechanic and its a peice of piss to do just get a full geo setup when fitted and it will drive like a dream

 

[wastegate]

It is easiest than trying fitting shocks and absorvers:haha:

 

[MeisterR]

Its pretty easy, just make sure you check your spring pre-load and you are good to go.

 

[Sheldon]

just make sure to get your camber sorted after fitting.

as johnny said. dont just fit them and drive away.. get camber set up!

 

[.ep82GER]

as johnny said. dont just fit them and drive away.. get camber set up!

were should i set it,any pics dude???

 

[The_Notorious_C_A_T]

Don't set it yourself unless you are removing a set of coilovers that you can copy. And even if you do you still need to get it set up again properly.

I would fit the coilovers then just take it to someone to get it all setup properly and drive canny on the way there.

 

[GT-TD04]

I set mine,along with top and bottom camber and tracking etc
Takes a long time till you get it right but it can be done,then just get them checked

 

[WallaceGlanza]

The only thing you might have difficulty with is removing the 2 hub bolts as they can be tight, but if you have the tools it's not a problem.

 

[The_Notorious_C_A_T]

I found them much easier than the ones on the rear axle. I had to angle grind em off the first time lol, but much easier than once I had replaced em and greased them up.