what map sensors are you guys using?

[fur]

toyota_BG if you want to run 2.5 - 2.7 bar (36 - 39psi) you will need at least a 4 BAR map sensor, remember that when a map sensor is a 2 bar it can only read 1 bar of positive pressure likewise a 3 bar can only read 2 bar of positive pressure. The max boost a 3 bar map sensor can read is 2 bar or 29.xx psi.

 

[liam2368]

is there a difference between ep82 and ep91 map sensors?

 

[hybrid_G4E]

ok hold up people. first of all, you cant change the map sensor on the factory ecu.

NOW you tell me.

better yet, i should've searched.

 

[Kelly]

We have 3bar map sensor off Celica.

 

[hybrid_G4E]

We have 3bar map sensor off Celica.

but not interchangeable with the stock MAP, rite? :argue:

 

[Kelly]

but not interchangeable with the stock MAP, rite? :argue:

Well we have power fc so its ok with that.

 

[Aga]

whow the thread is back from the dead.

 

[hybrid_G4E]

whow the thread is back from the dead.

blame the search function

 

[toyota_BG]

OK i'm having (EXCUSE ME for my English) ( my better side is DRAG ) what was i' sayeng o yeeah I'm having problems finding that 3.0 BAR Apexi map sensor. ( I'm from Bulgaria ( Eastest point of European Union) so i orderd everithing from internet)

Can you give me some direct link or some part number of that Apexi 3.0 bar map sensor

If this is against the rules please send me a PM.

And toyota rules all :rockon:

 

[Aga]

http://www.rhdjapan.com/jdm-low/APEXi-3-Bar-Sensor-Power-FC-D-Jetro-AVC-R-D-Jetro-23648

 

[Starbus]

um well yeh it would be a good idea. i belive that map sensors use diffrent voltage's for the signal so you would need to get one that read's a wider band but has the same voltage as the standard one.

someone on this site must know more about it. i would like to know more about this as well. on the emanage you can see when the map sensor get's to its limit as the line on the graphs goes' flat lol.

That would be impossible as they as they read 0-5volts.

For most car's the power FC's come with there own map sensor. Which is a 3 bar 1. So you can read to nearly 2 bar.

If this isn't the case with you, i'd go for 1 of them. Please bare in mind you'd need a remap afterwards. If your not mapped yet, then it's a simply tweak before you start.

 

[Aga]

if you fit a 3bar apexi map sensor on a powerfc and choose the precalibrated selection on the commander or laptop you dont need a remap. you only need a remap if you wanna run more boost than 1.3, which will mean you have to change the fuel and ign map's scale.