Guess my BHP

TurboDave

TurboDave

Member +
Been to Weston Performance today for a remap of the E-Manage so its time for a guess my BHP/Torque.

Dane your not allowed to guess :p and the boost was spiking to 1.2 bar settling at 1.1 bar.


Spec;

Weisco 75mm low comp forged pistons
Scat forged rods
TRD 0.6mm Head Gasket
Full Toby forged engine rebuild
Custom filter relocated to bumper
Apexi Power Intake
Custom 2.5 inch exhaust system 4" tip
WEPR FMIC
Custom intercooler spray
Blitz decat
Hybrid CT9 Turbo
E-Manage blue
SPS Mild steel race coated manifold
330cc Injectors
225lph fuel pump
Sard rrfpr
Magnecor leads
Iridium plugs
HKS actuator
Dawes device
Exedy Racing Organic Clutch

Happy guessing.

:)
 
TurboDave

TurboDave

Member +
Here are the graphs, 220.8bhp and 210ftlbs torque. IM really happy with the result because as you can see from the graphs there is almost no lag what so ever, the bhp curve is nice and smooth and it holds over 200ftlb's torque for over 2000rpm :)

My original plan was to run 1.4 bar but the boost controller was acting up and the turbo is going to need a rebuild soon as it used to creep to over 1.4 bar at 7000rpm but its now dropping off so we settled on this boost. Next on the list is the turbo sent off for a recon and possibly some more tweeking, a 75 shot of nos with progressive controller and another remap to have the nitrous setup :).

scan0001-2.jpg



scan0002.jpg
 
Last edited:
N

Nick@TD.co.uk

Registered Trader <a href="http://www.TuningD
Nice work there dave, your hybrid is performing very well buddy, congrats you must be very happy with it?

~Nick
 
You must log in or register to reply here.
Top