hi guys, i was looking for info on changing wheel bearings and brake disks but cant find anything, i was wondering if there is any info or tutorial on here and if some one point it out, thanks
when fitting the hks actuator do i set the lenght to a low boost setting and then can i use my boost controller to turn it up as in set it to .6bar and turn it up from there? and is it true that you can only go up and not down past the predetermined boost on the hks actuator
thanks a million gtstu.. nah i seen a few different forums on the net and i was sure it was com to actuator but some clown said com was for the compressor so connect it to the turbo, threw me off, all is good so.
well lads, i just fitted my hks actuator and apexi avcr, just wondering do i connect the COM port on the solenoid to the actuator and the NO port to the turbo or the opposite way around,..
thanks for the reply durmz, not contradicting ya but i was told the injector was not needed and to wire the purple for engine rpm instead but on the acvr diagram it show rpm1 and rpm2???
coil or distributor maybe? i had a similar problem and turned out to be my distributor was shot... maybe someone else can offer you a more specific answer