Recent content by glanzaman92

no code comes up when i do that but what is happaning is when i have it grounded off of somthing else when i turn on the red lights the engine light flashes very fast and dosent go off but when i continue and turn on the car the light gose off and its normal but when i come on boost for a little...

Nice one man but my loom didn't have a ground on it were the diagram siad it should be so I grounded it somwere else and now my engine light keeps flashing wen ever I turn on the ignition any idea why this is happening ?

Hello lads need a little bit of help I have my fcd wired into my map sensor in the engine bay but I'd like to wire it in the car to the ecu . Dose anyone have a link to a diagram or dose anyone now what wires I need to connect them to in the ecu loom ? Any sort of help would be appreciated .

Thanks lad for the help sorted it all out it was my fcd messing up the map sensor

Didn't have time to do it today but I will tomorrow and the car starts but as soon as I even tip the throttle it just cuts out every time and I had a look and found out why the cts code came on wires on the temp plug were ripped off il change the map sensor and see if it helps but I don't get...

any one ?

hello lads i am a bit stuck i have 3 fault codes coming up when i test my glanza faults. i am getting fault : code 22 CTS ( and i have never herd of this ) code 31 MAP OR AFS (same codes ) code 34 Turbo pressure signal ( dont no what this is or where it is ) i had a look on the site and...