Recent content by middler1988

i have a spare head wid cam caps cams and inlet mani spares loads of stuff breaking gt

got 3 rods block and crank and loads of spares let me know

interested in the engine when would you have it available for collection if i wer to buy it and why did u decide to break the car?

old engine it was my old engine where the big ends have gone and new engine the top end has gone.. headgasket was done not so long before the big end went so i changed the lumps and low and behold top ends shagged... my old engine was far stronger than the new one more than likely because it...

.. so simply changine over ther head with a spare i have will be ok/?

some pictures burnt valves?

took the head off today because it was rattling .. inlet valves were fine but all the exhaust valves were yellow ish.. when pushing the valves down as they popped bak up there was quite a metal on metal tapping noise. i presume that was the noise i was hearing. the valves closing. thanks

post a few ideas i have a spare head do u think this will solve my problems.. its not knocking its rattling and the rattle gets louder with the rev.. any input would be good

so can i take the cups out of the 1995 and use them and my shafts in my ep82 with lsd gearbox. its the factory lsd i think in my 1994 thanks :)

where can i get a lsd shaft from ?

cum on tgtt heads :)

ok so what im trying to achieve is not possible? i will not be able to put the factory shafts on my lsd box what can i do

wicked has anyone had to do this before? just seems to easy lol thanks a lot ;P

would i need the hubs from the 1994 too ? im planning the big swap about tomorrow if all goes to plan

hmm my car used to be automatic but its converted to a manual... how do i go about removing the cups? do i need any tools?