Recent content by mikeyek4

1st post edited to non turbo starlet now! any body know what other model starlet engine will be a direct fit

rite lads, i got the leak behind the timing belt cover sorted,, it was the core plug that had popped,, i replaced with a new one put coolant in it then after and left it running for 5 min, then brought it for a drive & it over heated and was also putting water out the overflow pipe, so...

cheers man thanks..

does anybody know if the ep82 non turbo water pump runs off timing bely or power steering belt? and where to get one ,resonably priced?

is a core plug the same as a freeze/frost plug , that taps into the block?? when i pulled the car out the other day after being lying up for the winter, one of the freeze plugs on the front of the block had popped out,, i got a few freeze plugs and fitted one of them to the block ,then when i...

no i didnt remove cover yet, i will take it off for a look tomorrow

as a above , my ep82 starlet soliel,has being lying up for a year and when i started it there was coolant leaking from the lower timing belt cover any ideas of what is causing this leak

anybody know where to get parts for the ae91?

im looking for, some aftermarket jdm parts for my 1990 corolla , like wide wheels ,lips,wind deflectors, lowering springs etc its 1.5 limiteed edition jap import,, any body know where to get some nice mods for these??

hi all, i have an ep82 95 gt turbo and the engine needs replacing ,i have found a bare engine for it out of a glanza turbo and i am wondering is there any thing else i need to get from a glanza to make it run, ,some body said something before bout throttle body or a swirl pot?? any help...

any body know if the 5afe engine will do the job?

can a 5afe bottom block be used? it out of a 1990 japaneese import corolla 1.5se / ae91 i think

galway

rite i dont really know what to do as idont know what wiring will have to be done

i would like to replace it with the turbo engine but a second hand one costs around 900 here and i probably would have to send it to the engine shop to get the valve seals and headgasket done in it as most of the starlet turbo angines where im from have the shit driven outa them so i wouldnt...