Recent content by Sharv

  1. S

    Tial External wastegate issu

    I will disconnect it from the avcr and run it just on the spring pressure and see the outcome. I doubt it will be ok coz a friend of mine had the same problem with his wastegate and had to replace it.
  2. S

    Tial External wastegate issu

    In my opinion i dont fink that the spring is faulty as it boosts well but it shouldnt boost beyond 0.8 bar on off mode setting. I have even tried to reduce the boost pressure to 0.8 on my Apexi avcr but it keeps on boosting above that figure and i guess that it could be the diaphragm. I have not...
  3. S

    Tial External wastegate issu

    I have double checked the vacuum hoses which are connected to the boost controller ad everything is ok. However my mechanic did told me that it could be the wastegate itself which is faulty as mentionned above. Can it be repaired or should i replace the wastegate. Thanks
  4. S

    Tial External wastegate issu

    Hi Am having an issue with my tial external wastegate,38mm,v band model. Lately I have noticed that the boost pressure goes beyond the normal pressure,which is 0.8 bar on off mode setting. Even the screamer pipe does not scream as it usually does.I have been using this wastegate for the past...
  5. S

    Garrett T28 capable of??

    get in touch with Sacha/Wickedep.
  6. S

    Uprated Billet Cams Help!

    From what Sam told me,they can also be used with stock valves & valves springs. Those cams seem to be a good upgrade according to the video which he has posted on his site. I think it's better if you could get in touch with Sam and ask him before taking any decision.
  7. S

    Feedback For Tuning Developments

    Parts received this morning,excellent service :)
  8. S

    Haltech PS 1000

    Get in touch with Elison for the start up file coz he sent me a much better one compared to the one which Haltech mailed me. I can mail you the base settings at some point coz my friend/tuner of BMT Tuning is doing a wonderful job on my car... looking forward for some good results once he...
  9. S

    Haltech PS 1000

    Have been able to start the car thanks to the map and settings which you mailed me. Will mail you the data log once it s activated.
  10. S

    Haltech PS 1000

    U have a pm.
  11. S

    Haltech PS 1000

    on cranking injector power is 11.5v
  12. S

    Haltech PS 1000

    Have you got the base settings for the ps 1000? Haltech has mailed me a specific one and the injectors seem to be opening but it looks like it's got something to do with the trigger settings. Rpm signal is ok.
  13. S

    Haltech PS 1000

    Thks for the info,i'll double check the wiring.
  14. S

    Haltech PS 1000

    mail sent with the haltech base map
  15. S

    Haltech PS 1000

    I have wired the injectors in sequential and selected the option in the software. Injectors give 14.9 ohm and I've selected high impedence. The reading of duty cycle stays on zero. The trigger type is multitooth 24 and 1 I am using NE and G- for trigger + and trigger - (on the 26p plug)...
Top