Search results

What actually makes these work, Where do they get their signal from ?

As title says, Thanks

Hi, Whats the diameter of a td04 intake, Want to sort out a air filter before i get it back from being recond, Thanks

Hi all, Actuator hose does it go to the compressor housing or inlet manifold, Whats the best route for the oil feed, front or rear of turbo, Thanks

Ok guys, Bought a td04 with the cast-in curved intake compressor housing which had a hairline crack in it (didnt know when i got it) So i then bought a td04l took the compressor housing off to swap over and discovered that the compressor wheel is bigger than the original one. if i use the...

As title says lads, Just the bottom half needed, Pm me if you got one, Thanks..btw for glanza

Hi, As title says. I need the one with the straight intake instead of the curved one, Thanks

Anyone got a spare compressor housing with the straight intake instead of the curved type, Thanks

Hi lads, Which model and year of civic do i need for the rad for my td04 conv. Thanx

Hi, As title says, in the process of rotating my turbo so i need a bracket, Has anyone got one for sale or does anyone know where i can buy one from, Thanks

Hi guys, Bit of a long shot but as anyone got one of the above they dont need, 15" any colour, Thanks

Hi guys, I'm in need of a bare dash (none airbag type). Must be in good nick with no drill holes, Let me know soon as if you have one, Thanks

Hi all, Anyone know the spring rate of bc coilovers. The ride really is too hard and it skips goin over bumps, even on the softest settin. Or can anyone tell me the spring rate to get for a softer ride. Much appreciated

Hi lads as title says, Has anyone got one of these lying around they dont need, Must have a bov take off on it, Thanks

As title says, Also need a turbo to sump pipe, Thanks

Hi all, As title says for a glanza the one with the little fusebox on, Many thanks

Can anyone tell me where the red and blue wires go plz...The instructions i have are for the old type coil, Thanks

Anyone got one of the above, The one with the little fuse box and bonnet release, Also need both rear doorcards, Thanks

Hi lads, Turbo arrived today off a mates mate, Its the 04 with the built in elbow. Anyone fitted one of these, Any probs ?...Thanks

as above guys, thanks