ABS light

[malcolmgt]

My ABS light keeps staying on in my glanza.
All sensors are fine and my garage plugged it in and said something about power but power is getting to it. They suggested speaking to toyota?

Got MOT ASAP too.
Preaume you can't just cover the light up for a temp issue?

 

[Jay]

If they realise there is ABS on the car they should watch for the lamp to come on and go out after the car starts. That sort of depends on how well they check the car over though.

What fault code are you getting?

 

[malcolmgt]

Not sure dude as garage did it.
I'm not great with cars !

 

[Jay]

Neither am I lol..

If they could give you a bit more info it might help amigo.

 

[nistarbo]

As said it sorta depends how well they. Check. Any spark could sure in a timer for u either 5-10 second. Or wire it off another bulb so when it goes out then it does also. Best way would be to resolve the issue properly. But that cos be a short term solution

 

[malcolmgt]

ECU was saying there was no power getting to the ABS.
however there was power going to the ABS.

that was the issue!

 

[dac69er]

is it an intermittent power problem? have you tried resetting it at all? is there more than 1 power feed to it, 1 is fine, but the other isn't?

 

[malcolmgt]

Did the abs bridge and diagnostic check and the airbag light glasss continuously??