anyone fitted a gt engine into glanza?

[Rob_GlanzaV]

the only differences im aware of on the engines are thicker con rods and different ecu connection???

my glanza engine is officially rodger'd and i can pick a gt engine up a lot easier than a glanza so just wondered if it had been done and if id come across any issues?

thanks

 

[kieran.s gt]

you will need to swap inlet manifold and thermostat housing

 

[Aidan-G]

no you just have to swap a few sensors over cause the plugs are differant in the looms

 

[Rob_GlanzaV]

i see i see. this shouldnt be a problem, i need new crank, rod, sump and piston rings so while im doing it i might aswell fully re condition it and its gonna be cheaper to swap engine. ill swap mani and bits off glanza onto gt block and head

thanks

 

[MARK@CMBAUTOS]

you will need to swap inlet manifold and thermostat housing

no you just have to swap a few sensors over cause the plugs are differant in the looms

either way its easy enough iv run a glanza engine

 

[Aidan-G]

i see i see. this shouldnt be a problem, i need new crank, rod, sump and piston rings so while im doing it i might aswell fully re condition it and its gonna be cheaper to swap engine. ill swap mani and bits off glanza onto gt block and head

thanks

you dont need to swap the mani on to the head

 

[Rob_GlanzaV]

i see i see. this shouldnt be a problem, i need new crank, rod, sump and piston rings so while im doing it i might aswell fully re condition it and its gonna be cheaper to swap engine. ill swap mani and bits off glanza onto gt block and head

thanks

 

[Rob_GlanzaV]

sorry about all same messages guys my internet is stupid where i live im stuck with one of them shit usb stick things but anyway wicked now i just need a engine