Apexi Power FC 3 bar Map Sensor

[Killamats]

A friend of mine just fitted a 3 bar map sensor but for some reason the car is kind of hitting fuel cut at 1 bar.

Would anyone know whats the reason behind this? Is there any setting that needs to be changed on the Power FC?

Thanks in advance

Keith

 

[NosydneW]

I have one of these too waiting to be fitted. if someone can put up some info on this it would be great.

where did your friend get the connector plug to fit on the apexi 3 bar sensor ? Cause to standard map sensor plug doens't fit the 3 bar apexi sensor.
And did he just replace the standard one to the apexi or does he have both map sensors fitted ? ( not)

 

[Rory]

I had the same type of issue on Monday, but my tuner reset the scalar and offsets to suit.
I cant get to them as i dont have the cable to read the PFC.

Nosy - Speak to Mark@CMBautos, he will get you a plug to suit. Replace the standard one for the Apexi one also

 

[weeJohn]

You need a datalogic and Universal FC software to access the settings for the map sensors.

 

[NosydneW]

OK I will contact him.

I Do have a datalogit and FC software so that should be a issue then if I have the plug

 

[weeJohn]

OK I will contact him.

I Do have a datalogit and FC software so that should be a issue then if I have the plug

I just wired it onto the stock map sensor wires.