great cars, look out for crunchy 2nd and 3rd gears, Mafs are weak on them, rear brakes seize.
If you want to do a diagnostics check on your car, go down to the foot pedals steering rack area and you should see two black connectors and two green. To do a diagnostics plug the black ones together and turn the ignition on (don't turn the engine on) if all is clear the engine check should blink in half second intervals. If there are any problems for example 23 the light will flash slow twice and then 3 quick flash's.
1.Engine Speed Signal Circuit 11.Crankshaft Position Sensor 12.Starter Signal 13.Camshaft Position Sensor 14.Fuel Injector No. 1 (Legacy, Impreza, Justy, SVX) 15.Fuel Injector No. 2 (Legacy, Impreza, Justy, SVX) 16.Fuel Injector No. 3 (Legacy, Impreza, Justy, SVX) 17.Fuel Injector No. 4 (Legacy, Impreza, SVX) 18.Fuel Injector No. 5 (SVX) 19.Fuel Injector No. 6 (SVX) 21.Engine Coolant Temperature Sensor 22.Knock Sensor 23.Mass Air Flow Sensor Circuit 24.Idle Control System Malfunction 24.ISC Valve (Stick) 25.Open/Short in ISC Valve Circuit 26.Intake Air Temperature Sensor 27.ATF Temperature Sensor Circuit 28.Knock Sensor #29.Crankshaft Position Sensor 2 31.Throttle Position Sensor Circuit 32.A/F Sensor #1 System32A/F Sensor #2 System 33.Oxygen Sensor 34.Vehicle Speed Sensor 35.CPC System 36.Turbine Speed Signal 37.Rear O2 Sensor Circuit / A/F Sensor Circuit Malfunction 38.Torque Control Signal #138Torque Control Signal #238Torque Control Signal System38Torque Permission Signal 39.Traction Control System 41.Air/Fuel Adaptive Control 42.Idle Switch 43.Accelerator Pedal Switch 44.Turbocharging Pressure Control Signal 45.Pressure Sensor 46.Neutral or Parking Switch or Circuit 47.Fuel Injector 48.Lean Burn System 49.CO Resistor 51.Neutral Position Switch 52.Parking Brake Switch (Exc. Justy)53.Antenna 53Anti-Quick Operation Mode53Communication Error (Time Over)53EGI Control Module EEPROM53IMM Circuit Failure (Except Antenna Circuit)53IMM Control Module EEPROM53Key Communication Failure53Reference Code Incompatibility53Use of Unregistered Key 54.Air Intake System 55.EGR Valve Lift Sensor 56.EGR System 57.Canister Control System 58.Air Control System 61.Air Suction Control Solenoid Valve 62Exhaust Manifold Valve Negative Pressure Control Solenoid 64Relief Valve Control Solenoid Valve 164Relief Valve Control Solenoid Valve 2 65Differential Pressure Sensor 66Twin Turbocharger System(H)66Twin Turbocharger System(S)66Twin Turbocharger System(T)66Two Stage Twin Turbocharger System 67Exhaust Manifold Valve Positive Pressure Control Solenoid 68Turbocharging Pressure Control Output Signal #2 71Shift Solenoid Valve72Shift Solenoid #2 Circuit 73Low Clutch Timing Solenoid Circuit 74Brake Clutch Timing Solenoid Circuit Malfunction 75Line Pressure Duty Solenoid Circuit 76Brake Clutch Pressure Duty Solenoid Circuit Malfunction 77Lock-Up Duty Solenoid Circuit 78Tiptronic Solenoid System 79Transfer Clutch Duty Solenoid Circuit 81Torque Up Control Valve 85Charger System Circuit Malfunction 86CAN (Communication System) 87Variable Induction Solenoid Valve Circuit Malfunction 88Fuel Pump Circuit Malfunction 89VVT Systems (L)89VVT Systems ® 91TCS Relief Valve 92Electrical Generation Control Signal Circuit Malfunction 93Vehicle Speed Sensor #1 Circuit 94Lateral G Sensor Signal Circuit Malfunction
Thats all the codes there.
To reset the ecu.
Ensure engine is at normal operating temperature, turn engine off
Locate the two ECU connectors, located under the steering column and consist of a black plastic male and female connector, and a green male female connector
With the ignition OFF connect black to black and green to green.
Turn on ignition, do not start the engine, depress the accelerator pedal to full throttle, then return it to the half-throttle position and hold for a few seconds, and then release
Engine Check lamp turns on
Start engine and then drive for at least one minute, keeping road speed above 11 Km/h.
ECU is now re-set.
At this point the check engine light should start to flash the all clear signal (steady 1/2 second interval flashes). If the check engine light does not flash, or indicates some other sequence, there is a fault present in the system, and should be professionally checked for necessary repairs.
Stop the car and turn off the engine.
Disconnect the black and green connectors.
Job complete.
The plugs your looking for.
Comes in handy.
