Ct9 external waste gate help!

L

little o1990

Fresh Recruit
as in the title im looking at going external wastegate on my standard ct9 i just genrally wanted to know how hard it is to do it i have an after market manifold but its not external wastegate but i have a friend whos really handy with a welder etc so what would i have to do??? quick replies much appreciated :D
 
M

Mikey4410

Member +
i to was going to go with external wastegate on my ct9 setup but it would cost a few quid .

i was going to do it coz i was worried about the boost creep issue,but it turns out if you have a decent hks actuator and a decent manual boost controller then it wont be an issue.i havent had over boost at all and i havent even ported the little standard wastegate !!

link for boost control :http://www.ebay.co.uk/itm/220834255382?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1439.l2649
really high quality and no boost creep issues

bits you would need would be a tial wastegate(only one to go with really),screamer pipe and a welder.the wastegates the expensive bit !
 
You must log in or register to reply here.
Top