E-manage BLUE ignition control setting

[Muddy_fox]

Hi! I just installed an emanage blue with main harness/injector harness and ignition control harness.

I'm having problem starting the engine, most of the time hard starting, if the ignition control connector is plugged in. But if I unplugged the ignition control harness and put a jumper wire on the blue-blue/white and keep the main harness/injector harness plugged in, there is no problem starting the engine.

Is it the setting for ignition control or it is because the ignition control of the emanage is not compatible with 4EFTE?

TIA

 

[ramses974]

hi
are you sure you have not done a mistake by wiring the ignition signal??
what kind of harness to you have ?stock greddy ? an harness
for ultimate?

 

[Muddy_fox]

Hi! if the ignition wiring is wrong will the engine start? bec. there are times that the engine will start without any problem, the car runs well, but there are times that the engine is hard starting.

Yes, I'm using the greddy original connector for emb.