Emanage Blue Questions. Help please asap

[starbuck]

1. Can i run my car with the blue fitted but not mapped?

2. How do i reset the ecu to wipe the previous MAP off.

3. What software version should i be using to do this, if needed..

Thanks in advance

 

[starbuck]

Anyone. One of you Blue users???

Please Help. Need the car for work, lol.

 

[starlet666]

u can run them with no settings on the maps, but it has to be setup for a 4efte motor to run the electronics, if it was mapped for a higher spec car, u will be able to drive it to get it mapped, if lower spec, just dont boost it and it should be fine, i have done it b4, but it is bare minimum driving with an untuned ECU, its not the best idea, but it can be done

 

[whiteglanzav]

wait till you go and get it mapped and let them fit it and map it at the same time,

dont run any boost above like 5psi untill its mapped if you have changed your setup

 

[starbuck]

I've fitted it already.

It was tuned for 1bar on standard CT9 4efte with supporting MODs previously.

My car is a CT9 on .65bar with almost the same MODs.

 

[stuarty1]

u should not hav to worry about that u can drive it to get it maped but dont boost as u need a proper map for ur car bud as the ecu needs to b set up again