EMU does not behave as normal ECU when all values are set to 0

perreau

perreau

Member +
Guys,

We checked and cross checked all wiring and found nothing abnormal.

Inj map 1 has to be set at -30 for car to idle properly and gives slight misfires when set at 0.

Ign map is set to 0 too.

This is our jumper setting for the EMU, looks OK right?

JP1-6: OPEN (to trim and add fuel)
JP7: 1-2
JP8:1-2
JP9: OPEN
JP10: OPEN (NOT USED)
JP11: OPEN
JP12: OPEN
JP13:OPEN
JP14: OPEN
JP15: 1-2
JP16: OPEN (NOT USED)
JP17: OPEN (NOT USED)
JP18: OPEN
JP19: OPEN (NOT USED)
JP20: OPEN (NOT USED)

What do we need to do to get the car to run same as standard ECU? Set everything to 0?

Cause we did that and still wouldn't work.

Regards,

Perreau
 
Chris@CCM

Chris@CCM

Member +
That what u need look it up on the greddy site I could put a link up but I'm using my iPhone and it's a pain lol good luck dude that's ur problem
 
perreau

perreau

Member +
Thanks a lot for your help guys. It turns out it was indeed missing the Inj. Adaptor 2. I got mine today and it sorted out all my probs. Special thanks goes to Azerty who went the extra mile to help a brother :)

How do i rep him?
 
perreau

perreau

Member +
Thanks a lot for your help guys. It turns out it was indeed missing the Inj. Adaptor 2. I got mine today and it sorted out all my probs. Special thanks goes to Azerty who went the extra mile to help a brother :)

How do i rep him?
 
You must log in or register to reply here.
Top